1. OPERATIONAL OVERVIEW
1-47
1.36.4 Trail level
The level, or intensity, of the afterglow that extends from radar targets can be selected
as below.
1. Select the [TRAIL] box at the bottom-right corner of the screen, then press the
right button to display the [TRAIL MENU].
2. Select [TRAIL LEVEL], then push the ADJUST knob.
3. Select the appropriate setting, then push the ADJUST knob. The higher the num-
ber, the greater the intensity of the afterglow.
4. Close the menu.
1.36.5 Narrow trails (Non-IMO only)
Target trails can be painted with thinner lines if desired. This can be useful when there
are a lot of targets on the screen and it is hard to distinguish one from another.
1. Select the [TRAIL] box at the bottom-right corner of the screen, then press the
right button to display the [TRAIL MENU].
2. Select [NARROW TRAIL], then push the ADJUST knob.
3. Select the appropriate setting from [OFF], [1] or [2], then push the ADJUST knob.
[2] is thinner than [1].
4. Close the menu.
1.36.6 How to hide the trails temporarily
Following the procedure outlined in "Trail time" on page 1-46, set the trail time to
[OFF]. The trails are hidden from view, but are continued. To show the trails again,
repeat the procedure, setting the trail time to any interval other than [OFF].
1.36.7 Trail stabilization in true motion
True motion trails can be ground stabilized or sea stabilized. The [TRAIL] box shows
current stabilization as "TRUE-G" or "TRUE-S". To change stabilization mode, open
the [SHIP SPEED MENU] menu and set [SHIP SPEED] to [LOG(BT)] (ground stabili-
zation) or [LOG(WT)] (sea stabilization).
1.36.8 How to erase/restart trails
All trails can be erased (including those in the memory) and restarted to start fresh
trails.
To erase trails, select the [TRAIL] box, then press and hold the left button. You can
also press and hold TGT TRAIL key to erase trails.
To Next Page
Loading...
Need help?
General
