4. AIS OPERATION
4-6
4.6 How to Activate AIS Targets
When you convert a sleeping target to an activated target, that target’s course and
speed are shown with a vector. You can easily judge target movement by monitoring
the vector.
Sleeping targets within an acquisition zone are automatically changed to activated tar-
gets and are colored red. See section 3.15 for how to use acquisition zones.
4.6.1 How to activate specific targets manually
Note: Enable target data and acquisition beforehand.
Right click to show the [CURSOR] menuo[0 NEXT]o[TGT DATA/ACQ SET-
TING]o[ANY] or [AIS ONLY].
Activate an AIS target from the control unit (RCU-014)
Put the cursor on the symbol of the AIS target to activate, then press the TARGET
DATA key.
Activate an AIS target from the trackball unit
Place the cursor on the target you wish to activate for AIS tracking, then press the left
button.
SOG (Speed Over Ground) and COG
(Course Over Ground) vector
*1
*1
Vector shows STW (Speed Thru
Water) and CTW (Course Thru
Water) when water tracking mode is
selected at the radar.
Turning direction (ROT)
Heading line
*2
*2
If there is no heading data available,
the heading line is not displayed.
To Next Page
Loading...
Need help?
General
