FELCOM 82
H3-5
2.3.2 Turning on ECM
When sending a large number of pages and large images, turn on Error Correction Mode
or ECM. Otherwise, a communications error will occur. When the ECM is set to ON,
“EC” is displayed on the display and when it is set to OFF, “G3” appears. To turn on
ECM;
1. Turn on the fax machine while pressing and holding down [1] and [3].
2. Press [FUNCTION/NO] [8] [FUNCTION/NO] [FUNCTION/NO]
[FUNCTION/NO] [AUTO RCV/YES] in this order. Now the screen should show
FUNC0=000100010.
3. Press [AUTO RCV/YES] several times until FUNC 18=00000110 appears.
4. Press [0] [0] [0] [0] [0] [0] [1] [0] to turn off ECM.
The third digit from right is for ECM on and off.
5. Press [AUTO RCV/YES] and [RESET] in this order.
6. Turn off the unit and turn it on again.
2.3.3 Sending fax via voice line
To send fax via voice line, change the modem speed from 9600 to 2400 by following
steps below.
1. Turn on the fax while pressing and holding down [1] and [3].
2. Press [FUNCTION/NO] [8] [FUNCTION/NO] [FUNCTION/NO]
[FUNCTION/NO] [AUTO RCV/YES] in this order. Now the screen should show
FUNC0=000100010.
3. Press [0] [0] [0] [1] [0] [0] [0] [0].
00010010: 9600 bps, 00010000: 2400 bps
4. Press [AUTO RCV/YES] and [RESET] in this order.
5. Turn off the unit and turn it on again.
To Next Page
Loading...
Need help?
General
