FS-75/2550
A2-7
3. Channel Programming
System channel: 9998 muse be set “0”, refer to section “2. System settings”.
The FS-75/2550 can store up to 200 user channels,
See the table below.
Band(MHz) Channel
0 1-10
1 1-10
2 1-10
3 1-10
4 1-20
6 1-20
8 1-20
12 1-20
16 1-20
18 1-20
22 1-20
25 1-20
Procedure
1. While pressing and holding down the [CH] key, turn the power on.
2. Select the system channel 9999 by operating the FREQ/CH encoder.
3. Press the [CH] [7] [5] and [ENT] keys in this order. (Password)
4. Select the system channel 9998.
5. Press the [CH] [0] and [ENT] keys to enable channel programming.
6. Select an RX channel to be programmed by operating the FREQ/CH encoder.
Operating the FREQ/CH encoder changes the display as below.
7. Select the emission mode with the [MODE] key.
8. To enter an RX frequency, press the [Freq] key and enter a frequency with the
number keys, then press the [ENT] key.
9. Select a TX channel of the same channel as RX with the FREQ/CH encoder.
0.00
Frequency
Channel
Band
0 - 01
R
MEMO
J3E
0-01 R 0-01 T
25-20 T
25-20 R------
------ 99009998
9999
To Next Page
Loading...
Need help?
General
