FS-5000/8000
A3-6
2.2 Confirmation of settings
To confirm settings, press [RCL] [9] [9] [9] [9] and [ENT] in this order.
Then press [ENT] key successively.
System setting for GMDSS
FS-5000)
System channel:9982 (A.BK relay or R.ANT) ---- [1]: YES
Note) 9913:System Delay 10 ms
9917:50 ohm BK Relay 1:ON (Permanently)
*The 50 ohm BK is installed the TX FIL board.
FS-8000)
9913:System Delay 10 ms
9917:50 ohm BK Relay ON or OFF (depend on installation)
*The 50 ohm BK is installed the COMBINER board.
9917: 0 (ON/OFF)
9917: 1 (ON)
“BFO” setting frequency
The DSC and NBDP are connected, the BFO frequency should be set to 1700 Hz.
1700 Hz; [BFO] 1700 [ENT]
AT-5000
FS-5000T
Tx/Rx ANT
ANT BK Relay
Tx Rx
AT-5000
FS-5000T
Tx ANT Rx ANT
Tx Rx
or
AT-5000
FS-8000T
Tx/Rx ANT
Tx/Rx
AT-5000
FS-8000T
Tx ANT Rx ANT
Tx Rx
or
To Next Page
Loading...
Need help?
General
