FELCOM 82
H3-20
Character Format (8 bit None / 7 bit Odd)
Choose the character format for address calls sent from the HSD Terminal to the
FELCOM 82. Select 8bit (default setting) or 7bit depending on specifications of the
HSD Terminal.
Ignore DTR (Normal / Ignore)
When an HSD call is received, the FELCOM 82 responds to the call without checking
“DTR” signal from the terminal units. When “Norma” is selected, the FELCOM 82
check the DTR signal before the response.
2.9 About password
The system provides two handset menus: User and Administrator. The administrator
menu needs a 4-digit password. The system is delivered with the password set to 0000.
When the password is 0000, it has no effect and all menus can be called by anyone.
See Chapter 8 menu tree for the difference between the user and administrator menus.
2.9.1 Setting password.
To set a password;
1. Press [FUNC] [6] [7] to call “67 Password” menu on the handset.
67 Password
Old : - - - -
New: - - - -
Conf: - - - -
Enter:[Ent]
2. Type 0000 on the “Old” line. Asterisks appear in place of the
password.
3. Move the cursor onto the “New” line by using the down arrow key.
4. Type the new 4 digit password.
5. Move the cursor onto the “Conf” line by using a down arrow key.
6. Type new password again and press [Enter] key.
7. The message “Password is changed.” is displayed and the Main menu
appears 3 seconds later.
To Next Page
Loading...
Need help?
General
