FUTABA 10CAG User Manual

104
HOVERING ADJUSTMENTS (
HOV-THR
and
HOV-PIT
):
+RYHULQJWKURWWOHDQGKRYHULQJSLWFKDUH¿QHWXQLQJDGMXVWPHQWVIRUWKHWKURWWOHDQGFROOHFWLYHSLWFKFXUYHVLQGLYLGXDOO\
DIIHFWLQJSHUIRUPDQFHRQO\DURXQGWKHFHQWHUSRLQWDQGRQO\LQWKHQRUPDOFRQGLWLRQ7KH\DOORZLQÀLJKWWZHDNLQJRIWKH
curves for ideal setup.
Adjustability:
5RWRUVSHHGFKDQJHVFDXVHGE\WHPSKXPLGLW\DOWLWXGHRURWKHUFKDQJHVLQÀ\LQJFRQGLWLRQVDUHHDVLO\DFFRPPRGDWHG
• Both adjustments may be inhibited if not desired.
• Both adjustments may also be set to
NULL
, temporarily turning off the knob but maintaining the last memorized setting.
• Adjustments may be memorized and then the knobs returned to center point to use that amount of adjustment. Allows
easy use of the trimming knobs for multiple models. (Note that when memorization is repeated with the knob offset from
center, the trim value accumulates.)
• Adjustments are quickly reset to the initial value by turning the dial until the trim reads 0%, memorizing, then returning
the knob to its center position.
• Note that all functions, including these, assume the model hovers at half stick.
• Available in normal (
NORM
RUQRUPDOLGOHXS
NORM/IDL1
) condition only.
GOAL of EXAMPLE: STEPS: INPUTS:
Fine-tune hovering with the hovering
adjustments. Remember these affect
only the hovering (normal) condition.
Adjust throttle and collective pitch
curves until the model hovers nicely. In
ÀLJKWDGMXVWFROOHFWLYHSLWFKDQGWKURWWOH
curves near hover point independently
with
HOV-THR
and
HOV-PIT
knobs.
6WRUHQHZVHWWLQJVDIWHUÀLJKW
Open the
HOV-THR
function.
for 1 second.
(If
BASIC
, again.)
C
to
HOV-THR
.
Optional: change which knob adjusts
each hovering curve.
NULL
locks in
curve in last stored position.
C
to
VR
.
to desired knob and direction.
Store the current dial settings prior to
selecting another model.
C
to
RATE
.
for one second to store.
or VR(C) to center.
Close.
Open the
HOV-PIT
function.
C
to
HOV-PIT
.
Store the current dial settings prior to
selecting another model.
C
to
RATE
.
for one second to store.
or VR(A) to center.
Close.
Where next?
THR-HOLD
: see p. 99.
Setting up the Idle-Ups: Throttle and Collective pitch Curves and Revo. Mixing
(
TH-CURVE, PIT-CURVE, REVO. MIX
) for idle-ups: see p. 101.
D/R
,
EXP
: see p. 42.

FUTABA 10CAG Specifications

General

Brand	FUTABA
Model	10CAG
Category	Remote Control
Language	English