FUTABA 10CAG User Manual

86
Flap Setting (
CAMBER FLAP
)(
GLID
):
CAMBER FLAP
assigns the primary flap control [defaults to VR(A)] to allow
LQÀLJKWWULPPLQJWKHÀDSV
7KHXSGRZQWUDYHORIHDFKIODSFDPEHUIODSV
FLP1

2
) can be adjusted
LQGHSHQGHQWO\$OVRWKHFHQWHUSRVLWLRQRIWKHÀDSVHUYRFDQEHRIIVHW
NOTE: If
FLAP-TRIM
is activated, you can not use
CAMBER FLAP
function
simultaneously.
[Note] When changing the polarity of a rate, "change rate dir?" is displayed for a check. Please set up after
pressing DIAL for 1 second and canceling an alarm display.
GOAL of EXAMPLE: STEPS: INPUTS:
Ex: Set the maximum travel of
35
% of
WKHWRWDOÀDSWUDYHO
Open the
CAMBER FLAP
function.
for 1 second.
(If
BASIC
, again.)
C
to
CAMBER FLAP
.
$GMXVWWKHXSGRZQWULPDPRXQW
separately.
(Ex: adjust to
35%
.)
C
to
FLP1
. VR(A). to
35%
.
VR(A). to
35%
. Repeat.
Option: Adjust the center position of
ÀDSVHUYR
C
to
CENTER
. to desired point.
Close menu.
Adjustability:
•
Rate: -100% to +100%, with a default of +30%
•
Center position (
CENTER
7KHRSHUDWLRQUHIHUHQFHSRLQWRIÀDSFDQEHRIIVHWWRZLWKDGHIDXOWRI

FUTABA 10CAG Specifications

General

Brand	FUTABA
Model	10CAG
Category	Remote Control
Language	English