Before Use
Touch panel and HOME/EXIT & U.MENU/MON.
button are used for entering data.
Touch the panel with your finger or the attached
stylus pen, which is also used as a toolbox, to enter
data.
Touch Panel
so that you don't scratch the touch panel with anything hard
excessive force or drop anything on the panel.
panel due to environmental changes such as temperature, it
is not a defect and will cause no problems.
Color LED is made from many pixels.
Some pixels hold
lighting. Moreover, some pixels go out. And a screen may
is not failure.
Note:
The trim positions you have set will be stored in the
non-volatile memory and will remain there.
DANGER
The T32MZ's touch screen is very sensitive. To
avoid a
suggested that it be locked. Due to the touch screen's
sensitivity, allowing it to be touched during flight
by a neck strap hook, servo extension, or even your
hand could be dangerous. Please use the touch panel
This transmitter is equipped with digital trims.
Each time you press a trim button, the trim position
moves one step. If you continue pressing it, the trim
position starts to move faster. In addition, when
the trim position returns to the center, the tone will
graphics on the screen. To change the trim rate,
you must activate this through the function menu,
within the linkage menu. Touch the trim button and
you will access another screen which enables you to
change the trim percentages.
Digital trim
T4 T1
T3
T6
T2
T5
Touch softly the
Touch Panel with
the stylus pen or
your fingertips.
Touch panel operation
To Next Page
Loading...
Need help?
General
