＜
Linkage Menu
＞
HELICOPTER
AIRPLANE
GLIDER
The Failsafe function is used to set up positions that the
servos will move to in the case of radio interference.
Defines servo position when signals are lost and when
receiver battery voltage becomes low.
You may set either of two positions for each channel:
Hold, where the servo maintains its last commanded
position, or fail safe, where each servo moves to a
predetermined position. You may choose either mode for
each channel.
The T32MZ system also provides you with an advanced
battery monitoring function that warns you when the
receiver battery has only a little power remaining. In this
The battery failsafe may be released by operating a
Decide which channels you want to go to preset
positions, and which ones you want to maintain their
last commanded position. To select the fail safe mode
F/S mode setting:
time the button is touched, it toggles between [OFF] and
a position you did not command, land at once and check
your receiver battery.
Defines servo position when signals are lost and when
receiver battery voltage becomes low.
For safety, always set the fail safe functions.
■
Especially set the throttle channel fail safe function so that
to the slow side from the hovering position for helicopters.
Crashing of the model at full high when normal radio
waves cannot be received due to interference, etc., is very
dangerous.
■
If fail safe is reset by throttle stick movement, the fail safe
may be mistaken as an engine malfunction and will be reset
any doubts, immediately land.
B.F/S setting:
This function releases the predefined control from it's
held position after indicating that your receiver battery is
low.
To Next Page
Loading...
Need help?
General
