＜
System Menu
＞
HELICOPTER
AIRPLANE
GLIDER
T32MZ trainer system makes it possible for the instructor
to chose which channels and operation modes that can
be used in the student's transmitter. The function and rate
of each channel can be set, the training method can also
be matched to the student's skill level. Two transmitters
must be connected by an optional Trainer Cord, and the
Instructors’ transmitter should be programmed for trainer
operation, as described below.
When the Instructor activates the trainer switch, the
student has control of the aircraft (if MIX/FUNC/NORM
mode is turned on, the Instructor can make corrections
while the student has control). When the switch is
released the Instructor regains control. This is very
useful if the student gets the aircraft into an undesirable
situation.
Notes: This trainer system can be used in the
following manner;
1. In the T32MZ transmitter and the other transmitter,
if the channel order is different. It is necessary to
match the channel order in the Linkage Menu
when connecting it with other than a T32MZ.
Or
use "Trainer student channel setting function"
2. Be sure that all channels work correctly in both
Note: When using T32MZ on the student side, it is
necessary to turn on the power switch. (For other
transmitters, the student may use it off.)
To Next Page
Loading...
Need help?
General
