PACE Pressure Controller User Manual
[EN] English i K0443 Revision A
Introduction
This manual contains Installation and operating instructions for PACE Pneumatic Pressure
Controllers.
Safety
The manufacturer has designed this equipment to be safe when operated using the procedures
detailed in this manual. Do not use this equipment for any other purpose than that stated, the
protection provided by the equipment may be impaired.
This publication contains operating and safety instructions that must be followed to make sure of
safe operation and to maintain the equipment in a safe condition. The safety instructions are either
warnings or cautions issued to protect the user and the equipment from injury or damage.
Use qualified * technicians and good engineering practice for all procedures in this publication.
Pressure
Do not apply pressures greater than the maximum working pressure to the equipment.
Toxic Materials
There are no known toxic materials used in construction of this equipment.
Maintenance
The equipment must be maintained using the procedures in this publication. Further
manufacturer’s procedures should be carried out by authorized service agents or the
manufacturer’s service departments.
Technical Advice
For technical advice contact the manufacturer.
* A qualified technician must have the necessary technical knowledge, documentation,
special test equipment and tools to carry out the required work on this equipment.
General Specification
Display LCD: Colour display with touch screen
EMC EN61326
Electrical safety EN 61010-1, UL61010-1, CSA 22.2, No. 61010-1 and IEC 61010-1
Power Supply
PACE 5000: Input range: 100-240V (50/60Hz) 2A, Installation Catergory II, Fuse
T2AH250V
PACE 6000: Input range: 100-120/200-240V (50/60Hz) 5A, Installation Cater-
gory II, Fuse T5AH250V
Pressure safety Pressure equipment Directive - class: sound engineering practice (SEP)
To Next Page
Loading...
Need help?
General
