35
Removing the water temperature selector
knob:
1. To remove the water temperature selector knob,
pull the knob straight off.
Removing the console:
1. Disconnect the washer from the electrical supply
and release the console.
2. Tag each plug with the jack number, then discon-
nect the electrical harness from the electronic
control, release the wire harness rivets from the
back of the control and lift the console off .
4. Release the tab that is spread open by the left hand
screw as viewed from the front.
5. Release the (3) locking tabs at top rear edge of
the console and roll the console forward.
To Next Page
Loading...
Need help?
General
