To Next Page

To Previous Page

2. Remove the (3) screws from the top of the brace.

3. Remove the (2) screws from the rear of the brace.

4. Pull back to disengage the (2) tabs and lift the

brace off.

Removing the suspension springs:

1. Disconnect the washer from the electrical supply

and remove the top panel.

2. Hook the top of the spring to raise it about 1” to

release the top hook from center brace flange.

Allow it to drop about 6” to relieve the spring

pressure and then unhook the other end of the

spring from the tub.

Removing the top center brace:

1. Disconnect the washer from the electrical supply

and remove the top panel.

2. Release the tub springs and slide the water valve

assembly back.

3. Remove the (4) screws, two on each end, and the

(2) screws holding the detergent dispenser hous-

ing to the brace.

4. Raise the brace to disengage the tabs on the

brace from the side panels. Slide the brace

backward to release the tabs on the brace from

the slot in the detergent dispenser housing.

GE WSSH300G User Manual

Other manuals for GE WSSH300G