GE WSSH300G User Manual

38
Removing the console mounting brace:
1. Disconnect the washer from the electrical supply,
remove the console and front panel.
2. Release the wiring harness from the back of the
brace. Remove the (6) screws, one at the top and
two in the front on each side, holding the brace to
the side panels.
3. Release the (2) tabs on the dispenser drawer
housing, one on each side, and pull the brace
forward.
Removing the bellows (door boot):
1. Disconnect the washer from the electrical supply
and remove the front panel.
2. Release the hose clamp and remove the hose from
the top of the bellows.
3. A groove in the rear of the bellows
is placed over the lip of the outer tub
and held in place by a spring loop.

GE WSSH300G Specifications

General

Brand	GE
Model	WSSH300G
Category	Washer
Language	English