40
4. Work your way about one third way around the tub
then pull in on the inside flap of the bellows to seat
the bellows into the lip of the tub.
5. Using your thumb, start on the other side of the
top tab and force the bellows on in the other
direction. About one third of the way around, stop
and seat the bellows onto the tub lip. Then force
the remaining bellows on with your thumb and
seat it.
6. To install the spring, fold the front of the bellows
back into the tub.
7. Place the spring in the groove at the top of the bellows
and wedge a round object, about 3/4 “ in diameter,
between the weight ring and the bellows to hold the
spring in the groove.
8. Pull the spring with one hand while working it into
the groove with the other.
9. Remove the wedge, unfold the bellows, and
insert the advance rinsing technology hose.
Removing the weight ring:
1. Disconnect the washer from the electrical supply,
remove the front panel and disconnect the ad-
vance rinsing technology hose from the bellows.
To Next Page
Loading...
Need help?
General
