Important Parts
For safe use, the machine must be serviced periodically. To increase safety, periodically replace
the parts listed in the following Table of Important Parts.
Serious injury or a fire could result if they deteriorate or are damaged.
Table of Important Parts
Above important parts are vulnerable to aging and wear or deterioration and it is difficult to
determine the degree to which they have deteriorated during periodic service. To maintain
their proper function at all times, therefore, replace them with new ones after using them for a
specific period of time, even if no abnormality is found with the parts. If you find abnormalities
in these parts before their scheduled replacement time is reached, repair or replace them
immediately. If a hose clamp is deformed or cracked, replace it immediately.
When replacing the important parts, please contact a Gehl dealer.
Also check the hydraulic hoses other than the above important parts. If any abnormality is
found in them, retighten them or replace them immediately.
When replacing the hydraulic hoses, replace the O-rings and seals at the same time.
Check the fuel and hydraulic hoses according to the periodic schedule described below.
Refer to “Maintenance.”
Type of inspection Inspection item
Daily inspection Leakage from joints, hydraulic or fuel hoses.
Monthly inspection Leakage from joints, hydraulic or fuel hoses.
Damaged hydraulic or fuel hoses (cracks, wear and tear).
Annual inspection Leakage from joints, hydraulic or fuel hoses.
Deteriorated, twisted, damaged hydraulic or fuel hoses (cracks, wear
and tear) or hoses in contact with other parts of the machine.
Unit Important parts to be replaced periodically
Replacement Interval
Fuel hoses
Packing in fuel filler cap
Engine oil filter hoses
Heater hoses
Air conditioner hoses
Hydraulic hoses (Pump - delivery)
Hydraulic hoses (Pump - suction)
Hydraulic hoses (Travel motor)
Hydraulic hoses (Lift arm cylinder lines)
Hydraulic hoses (Bucket cylinder lines)
Hydraulic hoses (Quick hitch cylinder lines)
Hydraulic hoses (Pilot valve)
Hydraulic hoses (Auxiliary lines)
Seat belt
Working
equipment
Engine connection
Machine
body
Every 2 years
Every 3 years
Hydraulic
system
Fuel system
Heater & AC systems
To Next Page
Loading...
Need help?
General
