When Required
Replacing the Bucket or
Attachment
WARNING
Read the manufacturer’s instructions
manual for attachments not included in
this manual. DO NOT use attachments
that are not approved by Gehl.
Before performing maintenance or
repairs under the machine, set all
working equipment against the ground
or in the lowermost position.
Installation
IMPORTANT: Before installing a bucket
or attachment, make sure the mounting
area of the bucket (1) and the quick-hitch
(3) are clean.
1. Make sure the quick-hitch (3) lock levers
(2) are in the unlocked position.
2. While sitting in the operator’s seat with the
safety bar down, start the engine and tilt
the quick-hitch (3) forward.
3. Move the machine slowly forward and
raise the loader lift arms. The wedge-
shaped top edge of the quick-hitch (3)
must engage in the upper mounts of the
bucket or attachment.
4. Roll the quick-hitch (3) back while lifting
the bucket or attachment off the ground.
The quick-hitch (3) will slide into position.
5. Lower the bucket or attachment until it is
25 to 50 mm (1 to 2 in.) off the ground.
6. Stop the engine and raise the safety bar.
7. Push both quick-hitch (3) lock levers (2)
down, securing the bucket or attachment
in position.
To Next Page
Loading...
Need help?
General
