Perform the following inspections once every day before starting the engine the first time.
WARNING
Before operating, perform the daily inspections and make repairs immediately if any
irregularities are found.
Be sure to secure the engine hood or rear door when opening it. Do not open the
engine hood or rear door on slopes or in strong winds.
Inspecting and Replenishing the
Coolant
WARNING
Do not remove the radiator cap or drain
plugs when the coolant is hot. Stop the
engine, let the engine and radiator cool,
and loosen the radiator cap or drain plugs
slowly.
Inspection
1. Open the rear door.
2. Inspect the quantity of coolant in the
reserve tank (1).
The level should be between the upper
limit (H) and lower limit (L).
If it is below the lower limit (L), replenish.
Replenishing
1. Remove the reserve tank cap (2).
2. Add coolant up to the upper limit (H) of the
reserve tank (1).
If the reserve tank is empty, inspect for
fluid leakage, then inspect the radiator (3)
coolant level. If it is low, add coolant to the
radiator (3) first, then to the reserve tank.
3. Install the cap (2).
Daily Inspection (Every 10 Hours)
To Next Page
Loading...
Need help?
General
