Every 100 Hours
Cleaning the Water Separator
WARNING
Do not smoke or permit open flames
while handling fuel or working on the
fuel system.
Stop the engine in a well-ventilated
place and allow it to cool before
performing maintenance.
Clean up spilled fuel immediately.
< CTL55 / CTL65 / CTL75 >
: Closed
1. Open the rear door.
2. Close the valve (2).
3. Loosen the ring (3), then remove the case
(4), element (5) and indicator ring (6) and
clean them.
4. Inspect the O-ring, and if there are any
scratches or other irregularities, replace it.
5. Assemble the indicator ring (6), case (4)
and element (5) and tighten the ring (3).
6. Open the valve (2).
7. Loosen the vent plug (8) and bleed the
air.
8. Tighten the vent plug (8).
Refer to page 159, “Bleeding the Air from the
Fuel System.”
< CTL85 >
1. Open the rear door.
2. Close the valve (2).
3. Loosen the ring (3), then remove the case
(4), element (5) and indicator ring (6) and
clean them.
4. Inspect the O-ring, and if there are any
scratches or other irregularities, replace it.
5. Assemble the indicator ring (6), case (4)
and element (5) and tighten the ring (3).
6. Open the valve (2) and bleed the air.
Refer to page 159, “Bleeding the air from
the fuel system.”