MACHINE DESCRIPTION
Front, rear, Ieft and right
This manual refers the front, rear, left and
right of the machine as seen when sitting in
the operator’s seat with the bucket visible to
the front.
Designated operations
Use this machine primarily for the following
operations:
Carrying
Leveling
Loading
Features
Hydrostatic drive system
Roll Over / Falling Object Protective Structure (ROPS/FOPS), tilt-up ROPS
Low engine noise and exhaust emissions
Two-way auxiliary hydraulics
Pilot-operated joystick controls
Break-in period
When the machine is new, follow the instructions below when operating the machine for the
first 100 hours (as indicated on the hourmeter).
Using a new machine roughly without breaking it in will lead to quicker deterioration of machine
performance and may shorten the machine’s service life.
Warm up the engine and hydraulic oil sufficiently.
Avoid heavy loads and rapid operations. Operate with a load of about 80% of the maximum
load.
Do not start up, accelerate, change directions, or stop abruptly unless necessary.
To Next Page
Loading...
Need help?
General
