Gemini GEM-P9600 Programming Instructions

L
NAPCO Security Systems
X
GEM-P9600 Programming Instructions
WI777D 08/00
!
Page 13
Enter Time (Press the (
A
) button to set cursor.)
Enter the current time in the format HH:MMA/P, where HH=hours (01–12);
MM=minutes (00–59). Select Am or Pm by pressing any number button,
then press
J
once again to save.
Dealer Code
Directly enter the Dealer Code, including leading zeros. Use the
1
through 9 buttons. NOTE: Press the 0 button for a zero. Press
J
to save.
Re-enter the Dealer Code to verify the previous code. Press
J
to save.
Press NEXT (
E
) button to proceed.
NOTE:
The Dealer Code can be two or more digits (up to 6 digits).
CLEAR PROGRAM: Should it be necessary to create a new custom default program, (a) from the Dealer Program Mode,
press the
C button to enter the Address Program Mode; (b) access Location 4091 (Clear Program) or 4093 (Cold
Start); (c) press
J
and then (d) press the
C
button to exit the Dealer Program Mode. A “
SYSTEM TROUBLE/E09-00
SERVICE
” will occur. Press the
C
button to silence the keypad.
(Direct Entry)
ENTER TIME
(12:05A)
(Direct Entry)
DEALER CODE
••••••
(Direct Entry)
DEALER CODE
RE-ENTER
EXIT DEALER PROGRAM MODE: This completes the custom default program. Press the
C
button to enter the
Direct Address Program Mode for further programming or press the
C
button once again to end all programming and
resume normal keypad operation.
Clear Dealer Program (Erases Dealer Program)
This erases the dealer program. Use this feature to start a
customized default program. Program Data and System
Status Memory is erased where Scheduled Data and Zone
Descriptions are maintained.
Access address 4091, then press the
J
button. Data entry is not allowed.
NOTE: Enter Easy Menu Driven Program Mode to program system again.
GEM-RP1CAe2 Keypad
4091 ••
Cold Start (Erases Entire Program)
This erases the entire program including Program Data,
Zone Description Data, System Status Data, Schedule Data
and Foreign Language configuration(similar to a new
panel).
Access address 4093, then press the
J
button. Data entry is not allowed.
NOTE: Some features (schedules) can only be programmed again with the
Downloading Software.
GEM-RP1CAe2 Keypad
4093 ••
GEM-RP1CAe2 Keypad: Time, Dealer Code & Exit Dealer Program Mode

Gemini GEM-P9600 Specifications

General

Brand	Gemini
Model	GEM-P9600
Category	Security System
Language	English