Gemini GEM-P9600 Programming Instructions

X
GEM-P9600 Programming Instructions
L
NAPCO Security Systems
WI777D 08/00
!
Page 66
ZONE DESCRIPTIONS (GEM-RP1CAE2 KEYPADS ONLY)
Enter an identifying description for each
zone. Buttons 1 and 2 set the
cursor position; buttons 3 and 6
scroll numbers, letters, punctuation marks,
etc.
!
Position the cursor over the displayed
Zone Number (i.e., “01”) using buttons
1 and 2.
!
Change the Zone Number using buttons
3 and 6.
!
Position the cursor over the first
character of the description field.
Advancing the cursor between
characters, program a description of up
to two lines for the new zone using
buttons 3 and 6.
!
Press the
J
button to save. Advance to the next zone as in Steps 1 and 2 above and repeat this procedure until all zones have
been programmed.
!
Enter the new User Code using the number buttons (0-9). If an old code is displayed, program over it. To erase the digit at the
cursor, press G 0 button.
!
Press the
J
button to save the code in memory.
!
Repeat this procedure for each user. To proceed to Zone-Description programming, press the NEXT (E) button.
GEM-RP2ASe2 Keypad
USER01
(Direct Entry)
123___
Programming User Codes (GEM-RP2ASe2)
To Program User Codes
1. Enter 2-digit User Number
(01-96) directly using
number buttons (0-9).
2. Press the
A
button.
3. Enter Code (1-6 digits)
directly using number
buttons (0-9).
4. Press the
J
button to save
each code.
NOTE:
Press
G 0
button to clear character at cursor.
To continue press E or F button.
Programming Zone Descriptions
To Program Zone Descriptions
1. Set the Cursor Position using
buttons
1
and
2
.
2. Select characters for zone
description using buttons
3
and
6
.
4. Press the
J
button to save
each descriptor.
NOTE:
Press
G 0
button to clear character at cursor.
To continue press
E
or
F
button.
01-______________
________________
User Program Mode: Zone Descriptions

Gemini GEM-P9600 Specifications

General

Brand	Gemini
Model	GEM-P9600
Category	Security System
Language	English