GW Instek ASR-2000 Series - TraceData Commands; Data|Trace:sequence:clear; Data|Trace:sequence:recall

REMOTE CONTROL
53
Trace/Data Commands
Note
The TRACE and DATA node for the following
commands are functionally equivalent.
:DATA|TRACe:SEQuence:CLEar.................... 53
:DATA|TRACe:SEQuence:RECall................... 53
:DATA|TRACe:SEQuence:STORe................... 54
:DATA|TRACe:SIMulation:CLEar .................. 54
:DATA|TRACe:SIMulation:RECall ................. 54
:DATA|TRACe:SIMulation:STORe ................. 55
:DATA|TRACe:WAVe:CLEar .......................... 55
:DATA|TRACe:WAVe[:DATA]....................... 55
:DATA|TRACe:SEQuence:CLEar
Set
Description
Clears the sequence data for the selected save
memory (Seq0 ~ Seq9).
Syntax
:DATA|TRACe:SEQuence:CLEar
{<NR1>|MINimum|MAXimum}
Parameter
<NR1>
0~9
MIN
0
MAX
9
Example
:DATA:SEQ:CLE 1
Clears the sequence data from Seq1.
:DATA|TRACe:SEQuence:RECall
Set
Description
Loads the sequence data. This command is the
equivalent to recalling a sequence memory in the
Sequence mode.
Syntax
:DATA|TRACe:SEQuence:RECall
{<NR1>|MINimum|MAXimum}
Parameter
<NR1>
0~9 (Seq0 ~ Seq9).
MIN
0