Video Security Control Panel User Manual
When the cursor turns to , you can lengthen or shorten the selected time bar.
8. Optionally, you can select the schedule time bar,
And then click the icon to delete the selected time bar,
Or click the icon to delete all the time bars,
Or click the icon to copy the time bar settings to the other dates.
9. Click Save to save the settings and click cancel to exit the interface.
10. Click Advanced Settings button to set the pre-record time, post record time, video expired time, and audio
recording.
11. Click Copy to to copy all these settings to other Zones.
Click Apply to save the settings.
Operation
You can configure the partition, zone, trigger, siren, and fault warning audio in this section.
Click Remote Settings->Operation to enter the interface.
Partition: you can arm/disarm the partition, clear alarm, bypass, and recover bypass of the system.
Zone: you can bypass or recover bypass of the selected zone.
Tigger: you can select to turn on/off the selected trigger.
Siren: you can enable/disable the specified siren.
Fault Warning Audio: you can select the faulted keypad and select to disable the warning audio.
To Next Page
Loading...
Need help?
General
