Video Security Control Panel User Manual
{15} Video Live View Settings Programming Address:801
{2}～{5}Set the value as 1 to enable the live view.
{6} End the command.
3.2 Keypad Alarm Operation Code
Device Initialization 3.2.1
Video security control panel can be recovered through the alarm keypad initialization; see the command below.
{Installer Password} + {*} + {8} + {9} + {#}
The default password for the installer: 012345.
Security control panel Arming and Disarm 3.2.2
The operation of security control panel arming and disarming is the same. Take the password 1234 as an example,
and the command is shown below.
{1} + {2} + {3} +{4} +{#}
After the operation is completed, the arming status of the control panel will be changed (the status of arming will
be exchanged into disarming), vice versa.
Operation method: {User password} + {*} + {1} + {7} + {#}.Take the password 1234 as an example, and the
command is shown below:
{1} + {2} + {3} + {4} + {*} + {7} + {#}
After the operation is completed, the partition will change the status of disarming (current status) into arming
immediately. The exiting delay of partition is 0.
To Next Page
Loading...
Need help?
General
