Video Security Control Panel User Manual
Telephone line
Disconnection
Main Operator Password Changing 3.2.11
The user password can be changed by main operator. The operations are divided into following steps:
Steps:
1. {Master Code} } + {*} + {0} + {#}
2. {User Number} + {#}
3. {New Password} +{#}
4. {New Password}+{#}
The password will be changed by the above four steps
The User Number must be expressed into three bytes, such as 002.
Entering Partition System 3.2.12
See the command below to enter the partition system.
{*} + {3} + {n} + {#}
Control Panel Programming Operation 3.2.13
The security control panel can be configured via alarm keypad operation; configuration process is generally
divided into three steps:
Steps:
1. Enter the programming mode; see the command below:
{Installer Code} + {*} + {0} + {#}
2. Security control panel configuration operation (see section 3.1)
3. Exit programming mode; see the command below:
{*} + {#}
To Next Page
Loading...
Need help?
General
