HIKVISION DS-K1T981 Series User Manual

1) Tap on the device inial page.
2) Enter 0 in the pop-up window.
3) Tap to call the client soware.
6. T
ap Answer on the pop-up page of the client soware and you can start two-way audio between
the device and the client soware.
Note
If the device is added to mulple client sowares and when the device is calling the client
soware, only the rst client soware added the device will pop up the call receiving window.
7.11.2 Call Center from Device
Steps
1. Ge
t the client soware from the supplied disk or the ocial website, and install the soware
according to the prompts.
2. Run the client soware and the control panel of the soware pops up.
3. Click Device Management to enter the Device Management interface.
4. Add the main staon and the device to the client soware.
Note
For details about adding device, see Add De
vice.
5. Se
t the main staon's IP address and SIP address in the remote conguraon page.
Note
For details about the operaon, see the user manual of the main staon.
6. Call the cen
ter.
-
If you have congured to call center in the
Basic Sengs , you can tap to call the center.
-
If y
ou have not congured to call center in the
Basic Sengs , you should tap → t
o call
the center
7. Answers the call via the main staon and starts two-way audio.
Note
The device will call the main staon in priority.
7.11.3 Call Device from Client Soware
Steps
1. Ge
t the client soware from the supplied disk or the ocial website, and install the soware
according to the prompts.
2. Run the client soware and the control panel of the soware pops up.
3. Click De
vice Management to enter the Device Management page.
4. Add the device to the client soware.
DS-K1T981 Series Access Control Terminal User Manual
69

HIKVISION DS-K1T981 Series Specifications

General

Brand	HIKVISION
Model	DS-K1T981 Series
Category	Touch terminals
Language	English