Before the client can receive the event informaon from the device, you need to enable the events
of the resource and arm the device rst. For details, refer to and Enable Receiving Event from
Devices .
7.10.1 Enable Receiving Event from Devices
Before the client soware can receive event nocaons from the device, you need to arm the
device rst.
Steps
1. Click → Tool → Device Arming Control to open Device Arming Control page.
All the added devices appear on this page.
2. In the Auto-Arming column, turn on the switch to enable auto-arming.
Figure 7-11 Arm Device
Aer turned on, the device(s) will be armed. And nocaons about the events triggered by the
armed device(s) will be
automacally sent to the client soware in real-me.
7.10.2 View Real-Time Events
The real-me event informaon received by the client of the connected resources are displayed.
You can check the
real-me event informaon, including event source, event me, priority, etc.
Before You Start
Enable receiving events from devices before the client can receive event from the device, see
Enable Receiving Event from Devices for details.
Steps
1. Click Event Center → Real-me Event to enter the real-me event page and you can view the
real-me events received by the client.
Event Time
For encoding device, event me is the client me when it receives the event. For other
device types, event
me is the me when the event is triggered.
Face Recognion Terminal User Manual
111
To Next Page
Loading...
Need help?
General
