Category Error code Error message Value
EX_EWSLTO Timeout waiting for specified status on the local
host
232
Resource
(Unrecoverable)
EX_ENOCTG Not enough CT groups in the RAID 217
EX_ENXCTG No CT groups left for OPEN Vol use. 215
EX_ENOPOL Not enough Pool in RAID 206
SSB codes
An SSB code is error information that is output when an error occurs by
executing a CCI command. The SSB code is output to the CCI execution log
file or to the console. Identify the SSB code from an error code as follows:
• SSB code that is output to the CCI execution log file.
The following shows an example of a SSB code that is output to the CCI
execution log file.
Example:11:06:03-37897-10413- SSB = 0xb9a0,2089
The alphanumeric characters after the equal sign shows an error code.
The last four digits of alphanumeric characters on the left side of the
comma (,) is SSB1 (for example, b9ao), and the alphanumeric characters
on the right side is SSB2 (for example, 2089).
• SSB code that is output on the console.
The following shows an example of an SSB code that is output to the
console.
Figure 9-1 An example of SSB code that is output to the console
The alphanumeric characters after the "SSB=" show an error code. The
last four digits of alphanumeric characters on the left side of comma (,) is
SSB1 (for example, B9E1), and the last four digits of alphanumeric
characters on the right side is SSB2 (for example, B901).
The following describes the SSB codes returned by the replication commands
and the configuration setting command (raidcom).
SSB codes returned by the replication commands
When a replication command returns an SSB code, refer to the
troubleshooting information in the user document for the product as follows:
Command Product returning the SSB code
• paircreate
• pairresync
Hitachi TrueCopy®
9-22
Troubleshooting
Command Control Interface User and Reference Guide
To Next Page
Loading...
Need help?
General