Holden VF Ute Owner Manual (Holden-Localizing-Holden-6070613) - 2014 -
1st Edition - 4/3/13
7-74 Infotainment System
Hands-Free Phone
Using Bluetooth
®
Voice
Recognition
To use voice recognition, press the
b / g button on the steering wheel.
Use the commands below for the
various voice features. For
additional information, say “Help”
while in a voice recognition menu.
Making a Call
Calls can be made using the
following commands.
Dial or Call: These commands can
be used interchangeably to dial a
phone number.
Digit Dial: This command allows a
phone number to be dialed by
entering the digits one at a time.
Re-dial: This command dials the
last number used on the mobile
phone.
Using the “Dial” or “Call”
Command
To call a number:
1. Press
b / g. The system
responds “Please Say a
Command,” followed by a tone.
2. Say “Dial” or “Call.”
3. Say the entire number without
pausing. The system responds
with the entered number.
4. Say “Dial” or “Call”.
Once connected, the person called
will be heard through the audio
speakers.
To call using a name tag:
1. Press
b / g. The system
responds “Please Say a
Command,” followed by a tone.
2. Say “Dial” or “Call” and then say
the name tag. For example “Call
John at Work.”
Once connected, the person called
will be heard through the audio
speakers.
Using the “Digit Dial” Command
This allows a phone number to be
dialed by entering the digits one at
a time.
1. Press
b / g. The system
responds “Please Say a
Command,” followed by a tone.
2. Say “Digit Dial.”
3. Say each digit, one at a time, to
dial. After each digit is entered,
the system repeats back the
digit it heard followed by a tone.
After the last digit has been
entered, say “Dial.”
If an unwanted number is repeated
back, say “Clear” to clear the last
number.
Once connected, the person called
will be heard through the audio
speakers.
Using the “Re-dial” Command
1. Press
b / g. The system
responds “Please Say a
Command,” followed by a tone.
To Next Page
Loading...
Need help?
General
