HOLDEN VF UTE 2014 User Manual

Black plate (7,1)
Holden VF Ute Owner Manual (Holden-Localizing-Holden-6070613) - 2014 -
1st Edition - 4/3/13
Vehicle Care 10-7
at highway speeds the dilution
elements evaporate, resulting in a
sudden drop in oil level.
Different dipsticks are used
depending on engine variant.
Arrows indicate the lower and upper
area/marks.
Adding engine oil
See Recommended Fluids and
Lubricants on page 11-2 and
Capacities and Specifications on
page 12-7.
1. Rotate the engine oil filler cap
anticlockwise and remove.
2. Add enough oil to reach within
the upper area/mark.
3. Check the level on the dipstick
and add further oil if necessary.
The engine oil must not exceed
the upper area/mark.
{
Caution
Overfilled engine oil must be
drained or suctioned out.
4. Replace the engine oil filler cap
tightly by rotating clockwise.
Note: Non-detergent and other low
quality oils, the use of break-in oil,
tune up compounds, friction
reducing compounds and other
supplemental additives are not
recommended. Their use increases
costs, may be detrimental to the
operation of the vehicle and may
void the New Vehicle Voluntary
Warranty, to the extent that Holden
considers the non-recommended
fluid to have affected the
specifications or quality of the
vehicle.
Engine oil change intervals
Refer to the Service/Warranty
Booklet.
Engine Coolant
Note: For all engine variants, the
coolant reservoir is in the same
position within the engine
compartment.

HOLDEN VF UTE 2014 Specifications

General

Brand	HOLDEN
Model	VF UTE 2014
Category	Automobile
Language	English