Holden VF Ute Owner Manual (Holden-Localizing-Holden-6070613) - 2014 -
1st Edition - 4/3/13
10-24 Vehicle Care
Number Plate Lamp
(W5W bulb)
1. Push the left hand side of the
lamp towards the right
hand side.
2. Remove the lamp from the
opening by pivoting the lamp
downwards.
3. Remove the bulb holder from the
lamp by rotating the bulb holder
anticlockwise.
4. Pull the bulb out of the bulb
holder.
5. Push the new bulb into the bulb
holder.
6. Install the bulb holder into the
lamp by rotating the bulb holder
clockwise.
7. Insert the right hand side of the
lamp into the opening and pivot
the lamp upwards into position.
8. Push on the left hand side of the
lamp until the clip engages.
9. Check lamp operation.
Interior Lamps
Cabin storage lamp
(Festoon bulb, 5W)
The vehicle may have cabin storage
lamps.
1. Gently prise away the lens
housing with a fine flat-blade
screwdriver.
2. Pull the tab holding the bulb
(opposite end to wiring)
backwards and pull the bulb out.
3. To install the new bulb, pull the
tab backwards.
4. When the new bulb is in place,
feed the wiring back into the
cavity and push the lens housing
back into place.
To Next Page
Loading...
Need help?
General
