Holden VF Ute Owner Manual (Holden-Localizing-Holden-6070613) - 2014 -
1st Edition - 4/3/13
10-38 Vehicle Care
.
Driving habits
.
Tyre pressures
.
Wheel alignment and balance
New tyres should be fitted in pairs to
the front. If replacing only one tyre,
pair it on the same axle with the
least worn of the other three.
{
Warning
Vehicles fitted with different size
tyres on the front and rear axles
cannot be rotated.
Buying New Tyres
Refer to the tyre placard on the
vehicle for tyre size and load rating.
Using a different size or type of tyre
may affect:
.
Ride
.
Handling
.
Speedometer accuracy
.
Vehicle ground clearance
.
Vehicle payload capacity
.
Maximum vehicle speed
.
Tyre clearance
.
Snow chain clearance
Tyres with heavy treads and those
made for better grip in the wet,
should only be operated within the
limits recommended by the
manufacturer.
Tyres with a higher speed or load
rating are acceptable, provided they
are fitted to a suitable rim size.
{
Warning
Tyres with a lower speed or load
rating are NOT acceptable for
fitment to the vehicle.
Replacing the factory fitted wheels
and tyres with non-genuine wheels
and tyres may affect the New
Vehicle Voluntary Warranty as well
as the vehicle's insurance policy.
Contact a Holden Dealer for advice
on suitable tyres.
Wheel Alignment and
Tyre Balance
Improper wheel alignment or
balance can cause:
.
Tyres to wear fast and unevenly
.
The vehicle to pull to one side
.
Vibration
If any of these problems exists,
have the vehicle checked by a
Holden Dealer.
Tyre condition is checked when the
vehicle is serviced by a Holden
Dealer. They are able to diagnose
any unusual signs of wear. If tyres
are rotated, it is recommended that
balance be checked at the
same time.
Tyre Chains
Due to lack of clearance, tyre chains
cannot be fitted to vehicles
equipped with the following wheel
and tyre configurations:
.
245/45R18 18 x 8
To Next Page
Loading...
Need help?
General
