Holden VF Ute Owner Manual (Holden-Localizing-Holden-6070613) - 2014 -
1st Edition - 4/3/13
Seats and Restraints 3-15
{
Warning
Always follow the child restraint
manufacturer's fitting instructions
when installing a child restraint
into the vehicle.
Note: Refer to the relevant
legislation, an approved child
restraint fitting station or capsule
manufacturer's information for the
recommended type of child restraint
to use.
Where to Put the
Restraint
{
Warning
Child restraint anchorages are
designed to withstand only those
loads imposed by correctly fitted
child restraints. Under no
circumstances are they to be
(Continued)
Warning (Continued)
used for adult seat belts,
harnesses, or for attaching other
items or equipment to the vehicle.
Only child restraints that have
clips to attach to the vehicle's
anchorage fitting (as shown in the
following illustrations) are to be
used. Earlier types of child
restraints may not attach securely
to this type of anchor.
Use only Standards Australia
approved child restraints and
harnesses. Only purchase a child
restraint which carries the
appropriate Standards Australia
sticker of approval.
Where legally allowable, you may
install a forward-facing child
restraint in the passenger's seat,
but always move the seat as far
back as it will go.
Child Restraint
Installation Locations
Anchorage points
.
Your vehicle has a single
anchorage point for the fitment
of a child restraint.
.
The anchorage fitting is located
behind the passenger seat on
the cabin wall.
To Next Page
Loading...
Need help?
General
