HOLDEN VF UTE 2014 User Manual

Black plate (21,1)
Holden VF Ute Owner Manual (Holden-Localizing-Holden-6070613) - 2014 -
1st Edition - 4/3/13
Vehicle Care 10-21
3. Remove the park lamp bulb by
pulling it straight out of the
holder.
4. Insert the new bulb into the
holder.
5. Install the holder by rotating
clockwise.
6. Install components removed in
Step 1.
7. Check lamp operation.
Front Turn Signal Lamps
1. The front turn signal lamps are
accessed by loosening the
wheel arch liner.
2. Using the torx tool from the
toolkit, see Tools on page 10-34,
remove the six screws at the
front of the wheel arch liner.
3. Dislodge the wheel arch liner to
provide access to the rear of the
front lamp.
4. Remove the turn signal bulb
holder by rotating anticlockwise.
5. Remove the turn signal bulb by
pulling it straight out of the
holder.
6. Insert the new bulb into the
holder.
Ensure that the same colour
bulb is used.
7. Install the holder by rotating
clockwise.
8. Check lamp operation.

HOLDEN VF UTE 2014 Specifications

General

Brand	HOLDEN
Model	VF UTE 2014
Category	Automobile
Language	English