CRANKCASE
1/2 REDUCTION UNIT WITH CLUTCH
DISASSEMBLY/ASSEMBLY (GX270 ONLY)
Drain the oil (page 3-5).
After installation, fill the oil
(page 3-5)
.
ASSEMBLY:
Note the installation
sequence.
O-RING
DRIVE CHAIN
ASSEMBLY:
Note the installation
sequence.
ASSEMBLY:
Align the groove of the
clutch weight holder with
clutch center key when
installing.
BEARING (6205)
CLUTCH FRICTION
DISC (2)
CLUTCH PLATE (2)
CLUTCH WEIGHT
HOLDER Assy.
BEARING (6206)
REDUCTION COVER
PACKING
DRAIN BOLT
DRAIN PLUG
WASHER
ASSEMBLY:
Be careful not to damage the lip of the oil
seal when installing the P.T.O. shaft into
the reduction cover.
P.T.O. SHAFT OIL SEAL
(30 x 50 x 7 mm)
REDUCTION COVER
BOLT (6 x 50 mm) (9)
SPRING
WASHER
BOLT (8 x 35 mm)
P.T.O. SHAFT
ASSEMBLY:
Attach the drive chain
to the P.T.O. shaft and
sprocket and install in
the reduction case as a
set.
DRIVE SPROCKET
CLUTCH
CENTER
KEY
ASSEMBLY:
Be careful not to damage the lip of the oil
seal when installing it onto the crankshaft.
THRUST
WASHER
BOLT (8 x 32 mm) (4)
REDUCTION CASE
CRANKSHAFT OIL
SEAL (30 x 46 x 8 mm)
REDUCTION OIL CAP /
OIL LEVEL GAUGE
DOWEL
PIN (2)
CLUTCH
CENTER
23 N·m (2.3 kgf·m, 17 lbf·ft)
To Next Page
Loading...
Need help?
General
