Honda GX390UT2 User Manual

FUEL SYSTEM
CHOKE SET REPLACEMENT
Remove the carburetor (page 6-8).
Pull out the choke valve plate (1).
Remove the choke shaft (2) and install a new choke
shaft.
Insert a new choke valve plate into the slit (3) of the
choke shaft.
Be sure the choke shaft is in the position between the
projections (4) of the choke valve plate.
CYLINDER STUD BOLT
REPLACEMENT
Thread two nuts onto the stud bolt and tighten them
together, and then use a wrench to turn the stud bolt
out.
Install new stud bolts.
(2)
(3)
(1)
(2)
(1)
(4)
(4)
SPECIFIED LENGTH
STUD BOLT (8 x 98) 82.0 mm (3.23 in)
STUD BOLT (8 x 106) 90.0 mm (3.54 in)
STUD BOLT (8 x 115) 99.0 mm (3.90 in)
STUD BOLT (8 x 123) 107.0 mm (4.21 in)
STUD BOLT (8 x 131.5) 115.5 mm (4.55 in)
STUD BOLT (8 x 115): 99.0 mm (4.55 in)
STUD BOLT (8 x 106): 90.0 mm (3.90 in)
STUD BOLT (8 x 131.5): 115.5 mm (4.55 in)
STUD BOLT (8 x 123): 107.0 mm (3.90 in)
STUD BOLT (8 x 98): 82.0 mm (3.90 in)
gx240ut2_gx270ut2_gx340ut2_gx390ut2

Honda GX390UT2 Specifications

General

Brand	Honda
Model	GX390UT2
Category	Engine
Language	English