Honda GX390UT2 User Manual

FUEL SYSTEM
AIR CLEANER REMOVAL/
INSTALLATION
Dual Element type:
NUT
AIR CLEANER
COVER
AIR CLEANER
ELEMENT (FOAM)
AIR CLEANER ELBOW
NUT (6 mm) (2)
CARBURETOR SPACER
AIR CLEANER
COLLAR (2)
BREATHER TUBE
WING NUT
AIR CLEANER
ELEMENT (PAPER)
INSTALLATION:
After installing the air cleaner elbow,
insert the breather tube to the hole
of the cylinder head cover as shown.
INSTALLATION:
Before installing, check for damage.
Note the installation direction.
Viewed from air cleaner side
REMOVAL/
INSTALLATION:
Remove and install the air
cleaner elbow with the
fuel valve lever in the OFF
position and the choke
lever in the CLOSE
position.
Before installation, clean
the inside of the air
cleaner elbow.
9 N·m (0.9 kgf·m, 7 lbf·ft)
GROMMET
WASHER BOLT
(6 x 22 mm)
COLLAR
AIR CLEANER
ELBOW SEAL
NOISE SILENCER
HIGH TENSION CORD
ANGLED CUT END
BREATHER TUBE
gx240ut2_gx270ut2_gx340ut2_gx390ut2
SERVICE BULLETIN #46 =>

Honda GX390UT2 Specifications

General

Brand	Honda
Model	GX390UT2
Category	Engine
Language	English