Honda GX390UT2 User Manual

GOVERNOR SYSTEM
CONTROL BASE ASSY.
DISASSEMBLY/ASSEMBLY
MANUAL OPERATION TYPE
Remove the control base assy (page 7-2).
CONTROL LEVER
SCREW (5 x 32 mm)
CONTROL BASE
CABLE RETURN SPRING
INSTALLATION:
Install with the short end
of the spring toward the
control base.
Hook the cable return
spring to the hole of the
control lever.
WIRE HOLDER
(If equipped)
SCREW (4 x 6 mm)
CONTROL LEVER
SPACER
LEVER SPRING
(If equipped)
CONTROL ADJUST
SPRING
ASSEMBLY:
Adjust the maximum
speed
(page 7-8).
CIRCLIP (5 mm)
(If equipped)
ASSEMBLY:
Install the control lever
washer by aligning the
cutout of the control
lever washer with the
claw of the control
base.
CLAW
SELF-LOCK NUT (6 mm)
ASSEMBLY:
After tightening the nut fully,
loosen it 1-1/2 turns.
ASSEMBLY:
Note the installation
direction.
STOPPER COLLAR
SCREW (5 x 25 mm)
(If equipped)
(If equipped)
(If equipped)
CONTROL LEVER
WASHER
gx240ut2_gx270ut2_gx340ut2_gx390ut2

Honda GX390UT2 Specifications

General

Brand	Honda
Model	GX390UT2
Category	Engine
Language	English