Basic Operation & Riding
93
Starting & Stopping the Engine
The recoil starter is used to start the engine when the battery is low.
To operate the recoil starter:
1. Turn the ignition switch to ON (
q
) and the engine stop switch to RUN
(
e
).
2.
Check that the transmission is in neutral.
3.
Grasp the starter grip (1) firmly, then pull it out slowly
approximately 100 mm (4.0 in).
4.
Pull the grip up briskly and fully.
5.
After the engine starts, allow the starter grip to return slowly.
Pull the recoil starter grip straight out so that the cord does not
touch the side cover. Repeated contact with the side cover can
damage the starter cord.
If the starter grip does not return smoothly (because of dirt in the
assembly), see your dealer.
Using the Recoil Starter
(1)
RIGHT SIDE
(1) starter grip
19 TRX500FA6 (ED)-32HR66400.book 93 ページ ２０１８年５月２２日 火曜日 午前１１時８分
To Next Page
Loading...
Need help?
General
