Instruments & Controls
31
Indicators & Displays
The digital clock (1) shows time with the clock mark (2) when the
ignition switch is ON (q).
To adjust the time, proceed as follows:
1.
Turn the ignition switch ON (q) and select the digital clock mode.
2.
Press and hold the mode select button (3) until the display start
blinking.
3.
To advance the display 1 minute at a time, press and release the
mode select button for 0.5 seconds.
Press and hold the mode select button the display will begin
advancing fast. Press and hold the button for:
• 0.5 – 5.5 seconds: advance one minute at a time.
• 5.5 – 10.5 seconds: advance five minutes at a time.
• 10.5 seconds or more: advance ten minutes at a time.
4.
Release the mode select button when the display reaches the
desired time.
5.
To end the adjustment, press and release the mode select button
for less than 0.5 seconds or turn the ignition switch to OFF (w).
After the battery is reconnected (page 203), check the clock.
Readjust the clock if necessary.
Digital Clock
(3)
(1) digital clock
(2) clock mark
(3) mode select button
(1) (2)
19 TRX500FA6 (ED)-32HR66400.book 31 ページ ２０１８年５月２２日 火曜日 午前１１時８分
To Next Page
Loading...
Need help?
General
