To Next Page

To Previous Page

7 - 2

All Symbologies

If you want to decode all the symbologies allowable for your imager, scan the

All

Symbologies On

code. If on the other hand, you want to decode only a

particular symbology, scan All Symbologies Off followed by the On symbol for

that particular symbology.

Message Length Description

You are able to set the valid reading length of some of the bar code symbologies.

If the data length of the scanned bar code doesn’t match the valid reading length,

the imager will issue an error beep. You may wish to set the same value for

minimum and maximum length to force the imager to read fixed length bar code

data. This helps reduce the chances of a misread.

EXAMPLE: Decode only those bar codes with a count of 9-20 characters.

Min. length = 09 Max. length = 20

EXAMPLE: Decode only those bar codes with a count of 15 characters.

Min. length = 15 Max. length = 15

For a value other than the minimum and maximum message length defaults,

scan the bar codes included in the explanation of the symbology, then scan the

digit value of the message length and Save bar codes on the Programming Chart

inside the back cover of this manual. The minimum and maximum lengths and

the defaults are included with the respective symbologies.

All Symbologies On

All Symbologies Off

Honeywell 5110 User Manual

Other manuals for Honeywell 5110