Honeywell NOTIFIER UDACT User Manual

UDACT Instruction Manual — P/N 50050:M 12/18/2009 33
Programming Options Programming Instructions
Table 3.1 Start and End Monitoring Addresses
3.4.12 UDACT Communication Selection (56)
Leaving address 56 at “0” disables communications to the Central Station(s). Enter “1” for zone
reporting, receive only, “2” for zone reporting, receive/transmit, “3” for point reporting, receive
only, or “4” for point reporting, receive/transmit. See “Type Mode” on page 52 for additional
information on detailed reporting.
ZONE REPORTING
START
(Factory
Default)
Valid Entries
END
(Factory
Default)
Valid Entries
AFP-100 01
2
01 01
2
01
AFP-200 01
1
01 02
1
01, 02
AFP-300/AFP-400 11
1
11 - 19 12
1
11 - 19
NFS2-640, NFS-640, NFS-320 20
1
20 - 32 32
1
20 - 32
System 500 01
2
01 01
2
01
System 5000 01
3
01 - 04 02
3
01 - 04
System 5000 with AIM-200 01
4
01 - 04 04
4
01 - 04
NFS-3030, NFS2-3030 01
5
01 - 32 User Defined 01 - 32
Note 1. Reports status of up to 99 zones
Note 2. Reports status of up to 56 zones
Note 3. Reports status of up to 120 zones
Note 4. Reports status of up to 248 zones
Note 5. Reports status of up to 1000 zones.
POINT REPORTING
AFP-100 01
6
01 04
6
04
NFS-320 20
7
20 - 32 32
7
20 - 32
AFP-300/AFP-400 11
8
11 - 19 19
8
11 - 19
NFS2-640, NFS-640 20
9
20 - 32 32
9
20 - 32
AM2020/AFP1010, NCA, NCA-
2, NFS2-3030, NFS-3030
01
10
01 - 32 User Defined 01 - 32
Note 6. Reports status of up to 198 points
Note 7. Reports status of up to 318 points
Note 8. Reports status of up to 448 points
Note 9. Reports status of up to 636 points
Note 10. Reports status of up to 2040 points
NOTE: For additional information on the starting and ending addresses, refer to the host FACP
Manual.

Honeywell NOTIFIER UDACT Specifications

General

Brand	Honeywell
Model	NOTIFIER UDACT
Category	Cell Phone
Language	English