HP 3100 Series User Manual

153
Enabling basic QinQ
A basic QinQ-enabled port tags an incoming packet with its PVID.
To enable basic QinQ:
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Enter interface view
or port group view.
• Enter Layer 2 Ethernet interface view or
Layer 2 aggregate interface view:
interface interface-type interface-number
• Enter port group view:
port-group manual port-group-name
Use either command.
3. Enable basic QinQ.
qinq enable
Disabled by default
Configuring selective QinQ (available only on the
HPE 3100 v2 EI)
Basic QinQ can only tag received frames with the PVID of the receiving port. Selective QinQ allows
adding different outer VLAN tags based on different inner VLAN tags.
You can configure an outer VLAN tagging policy in one of the following approaches:
• Port-based approach
• QoS policy-based approach
Configuring an outer VLAN tagging policy in the port-based
approach
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Enter interface view or port
group view.
• Enter Layer 2 Ethernet
interface view or Layer 2
aggregate interface view:
interface interface-type
interface-number
• Enter port group view:
port-group manual
port-group-name
Use either command.
3. Enter QinQ view and configure
the SVLAN tag for the port to
add.
qinq vid
vlan-id
By default, the SVLAN tag to be
added is the PVID of the
receiving port.
4. Tag frames of the specified
CVLANs with the current
SVLAN.
raw-vlan-id inbound
{
all
|
vlan-list }
N/A

HP 3100 Series Specifications

General

Brand	HP
Model	3100 Series
Category	Switch
Language	English