HP 3100 Series User Manual

181
LLDP configuration task list
LLDP-related configurations made in Layer 2 Ethernet interface view take effect only on the current
port, and those made in port group view take effect on all ports in the current port group.
Complete these tasks to configure LLDP:
Task Remarks
Performing basic
LLDP configuration
Enabling LLDP R
equired
Setting the LLDP operating mode Optional
Setting the LLDP reinitialization delay Optional
Enabling LLDP polling Optional
Configuring the advertisable TLVs Optional
Configuring the management address and its encoding format Optional
Setting other LLDP parameters Optional
Setting an encapsulation format for LLDP frames Optional
Configuring CDP compatibility (available only on the HPE 3100 v2 EI) Optional
Configuring LLDP trapping Optional
Performing basic LLDP configuration
Enabling LLDP
To make LLDP take effect on specific ports, you must enable LLDP both globally and on these ports.
To enable LLDP:
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Enable LLDP globally.
lldp enable
By default, LLDP is globally
enabled.
3. Enter Ethernet interface
view or port group view.
• Enter Layer 2 Ethernet interface view:
interface interface-type
interface-number
• Enter port group view:
port-group manual port-group-name
N/A
4. Enable LLDP.
lldp enable
Optional.
By default, LLDP is enabled
on a port.
Setting the LLDP operating mode
Step Command Remarks
1. Enter system view.
system-view
N/A

HP 3100 Series Specifications

General

Brand	HP
Model	3100 Series
Category	Switch
Language	English