HP 3600 v2 Series Configuration Guide

284
Task Remarks
Configuring a manual IPsec policy
Required
ACLs and IPsec tunnel addresses are not needed.
Applying an IPsec policy to an IPv6 routing
protocol
Required
See Layer 3—IP Routing Configuration Guide.
Displaying and maintaining IPsec
To do… Use the command… Remarks
Display IPsec policy information
display ipsec policy [ brief | name
policy-name [ seq-number ] ] [ | { begin |
exclude | include } regular-expression ]
Available in any view.
Display IPsec proposal
information
display ipsec proposal [ proposal-name ]
[ | { begin | exclude | include }
regular-expression ]
Available in any view.
Display IPsec SA information
display ipsec sa [ brief | policy
policy-name [ seq-number ] | remote
ip-address ] [ | { begin | exclude |
include } regular-expression ]
Available in any view.
Display IPsec session information
display ipsec session [ tunnel-id integer ]
[ | { begin | exclude | include }
regular-expression ]
Available in any view.
This command is supported
only in FIPS mode.
Display IPsec packet statistics
display ipsec statistics [ tunnel-id
integer ] [ | { begin | exclude | include }
regular-expression ]
Available in any view.
Display IPsec tunnel information
display ipsec tunnel [ | { begin | exclude
| include } regular-expression ]
Available in any view.
Clear SAs
reset ipsec sa [ parameters dest-address
protocol spi | policy policy-name
[ seq-number ] | remote ip-address ]
Available in user view.
Clear IPsec sessions reset ipsec session [ tunnel-id integer ]
Available in user view.
This command is supported
only in FIPS mode.
Clear IPsec statistics reset ipsec statistics Available in user view.

HP 3600 v2 Series Specifications

General

Brand	HP
Model	3600 v2 Series
Category	Switch
Language	English