HP 3600 v2 Series Configuration Guide

83
Specifying an access control method
You can specify an access control method for one port in Ethernet interface view, or for multiple ports in
system view. If different access control methods are specified for a port in system view and Ethernet
interface view, the one specified later takes effect.
To use both 802.1X and portal authentication on a port, you must specify MAC-based access control. For
information about portal authentication, see "Configuring port security."
To specify the access control method:
Step Command Remarks
1. Enter system view. system-view N/A
2. Specify an access
control method.
• In system view:
dot1x port-method { macbased |
portbased } [ interface interface-list ]
• In Ethernet interface view:
a. interface interface-type
interface-number
b. dot1x port-method { macbased |
portbased }
Optional.
Use either method.
By default, MAC-based access
control applies.
Setting the maximum number of concurrent 802.1X
users on a port
You can set the maximum number of concurrent 802.1X users for ports individually in Ethernet interface
view or in bulk in system view. If different settings are configured for a port in both views, the setting
configured later takes effect.
To set the maximum number of concurrent 802.1X users on a port:
Step Command Remarks
1. Enter system view. system-view N/A
2. Set the maximum
number of concurrent
802.1X users on a
port.
• In system view:
dot1x max-user user-number [ interface
interface-list ]
• In Ethernet interface view:
a. interface interface-type interface-number
b. dot1x max-user user-number [ interface
interface-list ]
Optional.
Use either method.
The default maximum
number of concurrent
802.1X users on a port is
2048.

HP 3600 v2 Series Specifications

General

Brand	HP
Model	3600 v2 Series
Category	Switch
Language	English