RSE-X1
Front view
Figure 1-8 Front view of RSE-X1
(1) Captive screw (2) Ejector lever
(3) SMB coaxial clock interface (reserved) (4) RESET button (RESET)
(5) CF card eject button (6) CF card slot
(7) CF LED (CF) (8) USB interface 0 (0) (host mode)
(9) USB interface 1 (1) (device mode) (10) USB interface 1 LED (USB)
(11) Link state/data reception & transmission LED (LINK/ACT)
(12) Management Ethernet interface (MANAGEMENT) (10/100/1000BASE-T)
(13) Console port (CONSOLE) (14) AUX port (AUX)
(15) Active LED of the RSE-X1 (ACT) (16) Power management alarm LED (PALM)
(17) Run LED (RUN) (18) Alarm LED (ALM)
Technical specifications
Table 1-10 Technical specifications for the RSE-X1
Item Specification
Processor MIPS 1GHz
Number of processor cores 2
Flash 4 MB
Memory type and size
DDR2 SDRAM
2 GB (default, two memory modules)
2 GB (maximum)
NVRAM 128 KB
Console port 1 (9600 bps to 115200 bps, 9600 bps by default)
AUX port 1 (9600 bps to 115200 bps, 9600 bps by default)
Management Ethernet interface 1 (10Base-T/100Base-TX/1000Base-T)
CF card
256 MB by default for the built-in CF card
256 MB, 512 MB, or 1 GB for an optional external CF card (CF
cards less than 256 MB are not supported)
USB interfaces
2 (USB 0: Type A connector, operating in the host mode; USB 1:
Type B connector, operating in the device mode)
Reset button 1
Dimensions (H × W × D) 45 × 399 × 412 mm (1.77 × 15.71 × 16.22 in.)
Power consumption 75 W
Hot swapping Supported
To Next Page
Loading...
Need help?
General
