Chapter 2
Installing the System
Cabling and Powering On the Server
90
Enter lc and press the
Return key. The lc command is displayed as shown in Figure 2-34.
Figure 2-34 The lc Command Screen
NOTE The value in the IP address field has been set at the factory. Obtain the LAN IP address from the
customer.
Step 3. At the prompt,
Do you want to modify the configuration for the customer LAN?
, enter Y.
The current IP address is shown; then the following prompt is displayed:
Do you want to modify
it? (Y/[N]
)
Step 4. Enter Y.
Step 5. Enter the new IP address.
The customer provides this address.
Step 6. Confirm the new address.
Step 7. Enter the MP host name.
This is the host name for the MP customer LAN. The name can be up to 64 characters long and can
include alpha numerics, -dash (-), under score (_), period (.), or a space ( ). HP recommends that the
name be a derivative of the complex name, for example, Acme.com_MP.
Step 8. Enter the LAN parameters for Subnet mask and Gateway address.
This information comes from the customer.
When this step is completed, the system will indicate that the parameters have been updated and
return to the MP Command Menu prompt (MP:CM>)
Step 9. To check the LAN parameters and status, enter the ls command at the MP Command Menu
prompt (MP:CM>).
MP:CM> lc
This command modifies the LAN parameters.
Current configuration of MP customer LAN interface
MAC address : 00:12:79:b4:03:1c
IP address : 15.11.134.222 0x0f0b86de
Hostname : metro-s
Subnet mask : 255.255.248.0 0xfffff800
Gateway : 15.11.128.1 0x0f0b8001
Status : UP and RUNNING
Link : Connected 100Mb Half Duplex
Do you want to modify the configuration for the MP LAN? (Y/[N]) q
To Next Page
Loading...
Need help?
General